Standard Horizon CPV350 Manual de usuario descargar pdf (Pagina 53)

Page 53CPV350

7. Move the ShuttlePoint to highlight REPORT and press [ENT] or move the ShuttlePoint

knob to the right.

8. Move the ShuttlePoint knob to highlight

NAME and press [ENT] or move the Shuttle-

Point knob to the right. A popup window will be shown.

9. Move the ShuttlePoint knob up/down to change the characters and left/right to select

a different character in the Routes Name.

10. When finished press [ENT] to save.

11. Press [CLR] to show the Chart page is shown.

10.3 INSERTING A WAYPOINT INTO A ROUTE

Place the cursor on the navigation line between two points and press [RTE]. Move the

ShuttlePoint knob to the desired location of the Waypoint and press [ENT].

10.4 GOTO A ROUTE

10.4.0 By select Route

1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)

on the Chart page.

2. Press [GOTO] to show the GOTO popup window.

3. Move the ShuttlePoint knob to highlight

ROUTE and press [ENT].

4. The SELECT ROUTE popup window will be shown.

5. Move the ShuttlePoint knob to the highlight the desired Route and press [ENT].

6. On the Chart page a circle with a Flag is shown on the first leg of the Route and a navigation

line is shown, indicating the GPS chartplotter is navigating to the first Waypoint in the

Route.

Figure 10.4.0 - Select a Route

10.4.1 By Cursor key

1. On the Chart page move the ShuttlePoint knob until the cursor reaches the starting point

of the Route.

2. Press [GOTO] to start following the Route.

3. Press [CLR] twice to revert to Home mode.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 143 144

Sin comentarios

Standard Horizon CPV350 Manual de usuario Pagina 53